Custom Adjust-A-Wall Systems
Design the custom system that best suits your needs. Easy to Order, Easy to Install
How to order custom Adjust-A-Wall
Systems:-
Select type of curtain material (vinyl laminate, tinted transparent, clear vinyl, cotton duck) from our materials page or page 38 from our catalog.
-
Select desired colors (vinyl laminate, tinted transparent or combination of colors) from our materials page or page 38 from our catalog.
-
Measure the height and order to exact height required. (+/- 1" tolerance). Floors are not always even, take measurement from highest point of floor. Factory deducts 2" from curtain height to allow for track and roller-hooks.
-
Determine the configuration of the Adjust-A-Wall System....straight run, two-sided "L" shape, three-sided "U" shape, four-sided enclosure "0" shape, or multiple stations (sketches are always helpful). Total up the number of linear feet (running length). Custom Partitions are sold by the linear foot of hardware required.
-
Determine installation method: Suspended (from overhead by cable, chain or threaded rod). Ceiling, Wall or Floor Mount. (Suspended is most common). Mounting option. See our mounting methods page or page 44 from our catalog for mounting options.
To help you with figuring your custom partition use this Order Form then fax it to us at 847-838-2222
The factory will determine and provide all necessary connectors, track and hardware based on the installation mounting method and configuration chosen. (Hardware is not provided with replacement curtains). Vinyl strip curtains can be included in combination with your Adjust-A-Wall System. Contact us for custom solutions.
Note: Minimum 2 shall be deducted from curtain height to allow for track & rollers. Normal tolerance is +/- 1 10% is added to curtain width for proper drape.
EASY TO INSTALL
The most popular method of erecting Adjust-A-Wall Partition Systems is suspension mount. Track is hung from overhead (beams or trusses) supported from chain, cable, threaded rod or angle iron (not provided). Upon installation of chain or other supports, the appropriate track connectors (Chain or Threaded Rod type) are attached to track at approximate 4 8 intervals to suspend the track. Once track is suspended in place at height desired, roller-hooks shall be inserted into track slot (1 roller per foot of curtain). Close track slot by installing end stop at each end of track. Hang the partition by inserting hooks through brass grommets along top edge of curtain. Curtains should reach approximately 1 or more above floor for smooth, fluid movement.
Call today!
847-838-6666
E-Mail - Sales-Info@Protools.ws
Mail - 23529 Eagle's Nest Road, Antioch, Illinois 60002
Home
What's New
Paint Booths
Prep Stations
Paint Mix Rooms
Air Make-up Systems
Air
Filters
Shop Curtains
Welding Systems
Welding
Blankets
Frame Benches
Floor
Anchors
Pulling Accessories
Super Seal
Roll Door
This page last updated on Thursday, August 04, 2022 08:14 AM.